The Auto Leveling sensor is a device that uses the hall effect to achieve Leveling.
The Position of the point can be obtained by touching the point on the heated bed and then compensated by adjusting the Z axis height during printing
Printing can also be achieved even though the heated bed is not flat
Cable Length:short 200mm long 1000mm
1* Leveling Sensor
1* 200mm Cable
1* 1000mm Cable
2* M3 nuts and screws
2* XH2.54mm Terminals
1* Coiling Terminal
Touch Auto Leveling Sensor Auto Bed Leveling Sensor BLTouch for 3D Printers
Only logged in customers who have purchased this product may leave a review.