BIGTREETECH SKR V1.3 Controller Board + TMC2208 UART Stepper Motor Driver + TFT3.5 Touch Screen Mainboard Kit for 3D Printer

$ 117.32

SKU: HOB1599010 Category:

Note:The TMC2208 in this Kit is Welding Completed into UART Mode
If you need the kit with TMC2208 General Mode, please
BIGTREETECH SKR V1.3
– 32 Bit LPC1768 Master Chip CPU Control Board
– Support Working Mode:TMC2208 UART & TMC2130 SPIUp to 256 subdivisions
– Support Auto Bed Leveling Sensor:BLTouch
– Microprocessor:ARM cortex-M3 CPU
– Input voltage:DC12V-DC24V 5A-15A
TFT3.5 Touch Screen
– ARM Cortex-M3 series STM32F103VCT6 chip with 32 – bit CPU 72MHz;
– Integrate Keil MDK5 development environment with mainstream development tools; Support online debugging, more helpful for product development and performance optimization, C language development, low development threshold;
– Update and configure firmware with SD card, easy to operate;
– Support serial wifi
– Support the functions of power off, continuous play, material failure detection, shutdown, etc.
TMC2208 V3.0
– Configuration:Supports three control modes of UART/STEP/DIR interface
– Microsteps:Up to 1/256
– MicroPlyer:1/256
– Logic Voltage VI0:3.3-5V
– Motor Voltage:4.75-36V
– Motor Phase Current:1.2A RMS, 2.0A Peak
BIGTREETECH SKR V1.3 GitHub / Manual
https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3
https://www.dropbox.com/s/x3cgq7tqbhk2yfd/SKR%20V1.3-Instructions.pdfdl=0
More Info about TMC2208 V3.0
https://www.dropbox.com/s/4czib44qqcb9sn3/TMC2208-V3.0%20specification%20.pdfdl=0
TFT3.5 Manual
https://github.com/bigtreetech/BIGTREETECH-TFT35-V2.0/blob/master/TFT3.5-V2.0%20manual.docx
Only Marlin firmware can demonstrate the full functionality of SKR V1.3.
https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/tree/master/firmware/smoothieware%2BTFT35
Package Included
1 x BIGTREETECH SKR V1.3 Mainboard
1 x TFT3.5 Touch Screen
5 x TMC2208 UART

Weight 0.083 kg

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.