200*200mm 200w 12v Waterproof Silicone Heating Pads for 3D Printer
Shipping:Standard Shipping about 10-25 business days
– Behind the back with adhesive or pressure-sensitive adhesive, double-sided adhesive, silicone heat sink can be firmly stuck to be added to the surface of the object.Easy to install.
– With a fever, temperature, high thermal efficiency, high strength, easy to use, safe and long life, not easy to old
3.Lead wire length:approx.60cm
6.Operation temperature:-60 to +200鈩/span>
8.Thermal protection:On board thermal fuse, thermostat, thermistor and RTD devices are available as part of your thermal management solution.
* Due to different producing batches, product details might be a little different.Thank you for understanding.
* Please allow 1-3CM differs due to manual measurement.
1 x 200*200mm Silicone Heater Bed Pad
Only logged in customers who have purchased this product may leave a review.
Customers Also Viewed
Creality 3D 888mm Width 6mm Rubber 2GT Open Timing Belt for 3D Printer Part$ 7.243D Printer AccessoriesAdd to cart
SpecificationsType:2GT-6mmGT2 Pitch:2mmMaterial:RubberLength:888mmWidth:6mmShape:Open timing beltFit for:3D PrinterPackage included1x Creality 3D® 2GT-6mm Rubber Opening Belt
AC110/220V DC24V 15A Heated Bed Regulated Switching Power Supply with on/off Switch for Ender-3 Pro 3D Printer$ 115.373D Printer AccessoriesAdd to cart
Specifications– Product type:24V 15A Power Supply – Output voltage:DC24V 15A– Input voltage:AC110V/240V – Voltage adjustable:± 10%– Overload protection:105% to 150% of rated power– Overvoltage protection:105% to 150% of rated power– Operating temperature:-20 °C to 60 °C (without frost)– Cooling type:Natural cooling– Shell structure:Aluminum / stainless steel– Modulation mode:Pulse width modulation– Link mode:Full bridge type– Product …
AC110/220V DC24V 15A Heated Bed Regulated Switching Power Supply with on/off Switch for Ender-3 Pro 3D PrinterRead More
3Pcs Filament Runout Sensor for 3D Printer Material Detection Module 1.75mm Filament Detecting$ 39.573D Printer AccessoriesAdd to cart
Introductions– This filament run out sensor unit is designed to detect whether your printing is run out of filament.– During printing, if the unit detected that there is out of filament it will send a signal to the main board.– With correct firmware settings, the printing will be paused until the operator reload the filament …
3Pcs Filament Runout Sensor for 3D Printer Material Detection Module 1.75mm Filament DetectingRead More
Creality 3D Brass T8 Lead Screw Nut Pitch 2mm for Stepper Motor 3D Printer Part$ 8.903D Printer AccessoriesAdd to cart
Specifications– Type:screw nut– Material:brass– Diameter:8mm– Lead:2mm– Direction of rotation:right-handed– Application:T-type screw, stepper motorPackage Included1 x Screw Nut
There are no reviews yet.